Power supplies#
Different BeagleBoard products require different power supplies. While BeagleBone Black and other AM335X based boards will be fine with a 5V @ 1A, others, such as BeagleBone AI-64 require aleast 5V @ 3A. You have to either supply the power via USB jack or a matching (center positive) barrel jack as shown in the table below.
Note
The power supply is not supplied with the board.
Board |
Connector |
Power |
Tested accessories |
---|---|---|---|
BeagleBone Black |
2.1mm Barrel Jack |
5V @ 2A |
|
BeagleBone Black Wireless |
|||
BeagleV-Ahead |
|||
Beaglebone xM |
|||
PocketBeagle |
microUSB |
5V @ 2A |
|
BeagleBone AI-64 |
Type-C |
5V @ 3A |
|
BeaglePlay |
|||
BeagleBone AI |
|||
BeagleV-Fire |
|||
BeagleY-AI |
|||
BeagleBone Green Gateway |
2.1mm Barrel Jack |
12V @ 5A |
|
Beaglebone Blue |
|||
BeagleBone X15 |
2.5mm Barrel Jack |
12V @ 5A |
|
Tip
Most modern day mobile phone chargers are capable of delivering enough current to power any BeagleBone. You may try using that with a suitable cable before buying any standalone power source for your board. Please ensure the expected output voltage and current capabilities are listed on your power supply before attempting to power your board.
If you plan to use capes or add your own circuitry, a power supply capable of higher current may be required.
Note
USB-C supplies will auto-negotiate the highest power mode that both power supply and BeagleBoard support. In most cases, this will be 5V @ 3A. It is OK to use a higher Wattage USB-C PD supply with a board, but it is recommended to use supplies from well-known manufacturers to avoid supplies that may break the USB-C PD specification.